ThingMagic Universal Reader Assistant 2.6 - Manual (Page 11)

Connect
Universal Reader Assistant v2.6 User Guide 11
Note: On some systems, especially when using the Direct to PC connection, the hostname must end in
“.local” for the connection to succeed. i.e. m6-21071f.local
  DHCP on the LAN - the reader should be identifiable using the automatic
hostname such as M6-XXXXXX (where XXXXXX is the last 6 digits of the MAC/
LAN address, seen on the barcode label) or using the ass
 
Static IP on the LAN - the assigned IP address should be used.
Once the connection is established the Status LED should change to YELLOW and the
Region selection in the Connect section will change to the region of the connected reader
as shown in Figure 3. On networked readers the region of operation cannot be changed.
Figure 3: Connected to a Network Reader
Once connected go to WebUI for persistent settings
Once a connection to a networked reader is established the WebUI button will become
active. Clicking on it will open up a browser to the readerʼs Web Interface which supports
modifying the network configuration and making persistent changes to the Performance
Settings of the reader. See the readersʼ Hardware Guide for details on using the WebUI.