Solution, Fault_flash_verify_failed – 306h, Cause – ThingMagic Micro Hardware User Manual
Page 77
Flash Faults
A D I V I S I O N O F T R I M B L E
72
Appendix A: Error Messages
Solution
When this occurs make note of the operations you were executing, save FULL error
response and send a testcase reproducing the behavior to [email protected].
FAULT_FLASH_VERIFY_FAILED – 306h
Cause
The module received a write flash command that was unsuccessful because data being
written to flash contained an uneven number of bytes.
Solution
When this occurs make note of the operations you were executing, save FULL error
response and send a testcase reproducing the behavior to [email protected].