ThingMagic Micro Hardware - Manual (Page 53)

Regulatory Support
A D I V I S I O N O F T R I M B L E
48 Functionality of the Micro
Regulatory Support
C A U T I O N ! ! !
Please contact ThingMagic support - [email protected] - before
beginning the process of getting regulatory approval for a finished prod-
uct using the Micro.
Supported Regions
The Micro has differing levels of support for operation and use under the laws and
guidelines of several regions. The regional support is shown in the following table.
Region Regulatory Support Notes
North America (NA) FCC 47 CFG Ch. 1 Part 15
Industrie Canada RSS-210
European Union
(EU3) Revised ETSI EN 302 208
Note:
The EU and EU2
regions are for
legacy applications
using old ETSI
regulations. These
should not be used.
By default EU3 will use four channels. EU3
region can also be used in a single channel
mode. These two modes of operation are
defined as:
Single Channel Mode
• Set by manually setting the frequency hop
table to a single frequency. In this mode the
module will occupy the set channel for up to
four seconds, after which it will be quiet for
100ms before transmitting on the same
channel again.
Multi Channel Mode
• Set by leaving the default or manually setting
more than one frequency in the hop table. In
this mode the module will occupy one of the
configured channels for up to four seconds,
after which it may switch to another channel
and immediately occupy that channel for up
to four seconds. This mode allows for
continuous operation.