beautypg.com

Tjernlund SS1R SideShot (Discontinued) with UC1 Universal Control (Version X.04) 8504117 Rev 02/04 User Manual

Page 8

background image

7

INSTALLATION

• Reciprocating Saw

• 1/2", 7/16",5/8" Wrench

• Vent Pipe

• Drill and 1/8", 1/4", 1/2" Bits, 1” hole saw

• 1/4" Masonry Drill Bit

• Wire

• Blade Screwdriver

• 1/4", 5/16”, 11/32" Nut Driver/Socket

• Wire Nuts

• Wire Cutter/Stripper

• Hammer

• 1” Strain Reliefs

• Tube Cutter

• Electrical Conduit

INSTALLING VENT HOOD TERMINUS

1. a) Fold template A along dashed line and attach in between the floor joists ensuring that it is snug against the sill plate and right

hand floor joist. Follow same procedure if floor trusses are used, (See Diagram B).

b) If the SS1-R is not being installed between floor joists, attach the template to the wall it will be exiting ensuring it is level.

It is not recommended for the SS1-R to be terminated on a wall that faces the direction of
the prevailing winds. Backdrafts by severe winds can cause oil odors to remain in the
structure and/or interrupt heating equipment operation.

DIAGRAM A1

DIAGRAM B

Rough-In
8” Height
8 3/8” Width

Tools required:

Materials required: