Rice Lake Valor 7000, Ohaus - Instruction Manual - Manual (Page 23)

Valor™ 7000
Series EN-21
4.8 COM1 Menu
Enter this menu to define communication parameters. Default settings are bold.
Note:
The COM2 menu is only displayed if a second interface is installed.
Reset
[reset]
Reset the COM menu to factory defaults.
NO = no reset
YES = reset
Baud Rate
[BAUD]
Set the baud rate.
300 = 300 bps
600 = 600 bps
1200 = 1200 bps
2400 = 2400 bps
4800 = 4800 bps
9600 = 9600 bps
19200 = 19200 bps
Parity
[paritY]
Set the data bits and parity.
7 EVEN = 7 data bits, even parity
7 ODD = 7 data bits, odd parity
7 NONE = 7 data bits, no parity
8 NONE = 8 data bits, no parity
Stop bit
[stOP]
Set the number of stop bits.
1 = 1 stop bits
2 = 2 stop bits
Handshake
[H.shake]
Set the flow control method. Hardware handshaking is only available for COM1 menu.
NONE = no handshaking
ON-OFF = XON/XOFF software handshaking
Reset:
no
, yes
Baud Rate: 300…9600…19200
Parity: 7 even, 7 odd, 7 none, 8 none
Stop bit:
1
, 2
Handshake:
none
, On-Off
Alternate command: Print (A…P…Z), Tare (A…T…Z), Zero (A…Z)
End COM: Exit menu