Rice Lake Valor 7000, Ohaus - Instruction Manual - Manual (Page 20)

EN-18
Valor™ 7000
Series
4.7 Print1 Menu
Enter this menu to set printing parameters. Default settings are bold.
Note:
The Print2 menu is only displayed if a second interface is installed.
Reset
[reset]
Reset the Print menu to factory defaults.
NO = no reset
YES = reset
Stable Only
[Stable]
Set the printing criteria.
OFF = values are printed immediately
ON = values are only printed when the stability criteria are met
Auto Print
[A.Print]
Set the automatic printing functionality.
OFF = disabled
ON.STAB = printing occurs each time the stability criteria are met 1
INTER = printing occurs at the defined interval 2
CONT = printing occurs continuously
ACCEPT = printing occurs each time the display is within the Checkweigh accept
range and stability criteria are met.
1 When ON.STAB is selected, set the condition for printing, where:
LOAD = printing occurs when the load is stable and greater than zero
LOAD.ZR = printing occurs when any load is stable and equal to or greater
than zero.
2 When INTER is selected, set the Print Interval.
1 to 3600 (seconds)
Reset:
no
, yes
Stable Only:
off
, on
Auto Print:
off
, on stable, interval, continuous, accept
Content: Result (-> off, on)
Gross (-> off, on)
Net (-> off, on)
Tare (-> off, on)
Header (-> off, on)
Footer (-> off, on)
Mode (-> off, on)
Unit (-> off, on)
Info (-> off, on)
Accu (-> off, result, all)
Layout: Format (->S,M)
Feed (->Line, 4 Lines, form)
Data Transfer: off, on
End Print: Exit menu