Rice Lake TradeRoute HL Series - Low Profile Operators Manual for Models from 2011 and Older 127465 - Manual (Page 35)

32
Symptom Probable Cause Action
The level light will
not illuminate a) the bulb is burnt
out
a) replace bulb Norac part #
101149
The level light will
not illuminate AND
the weight indicator
shuts off 10 seconds
after powering up
a) truck is more than
6 degrees off level
(Depending on
your application
you may be limited
to less than 6
degrees)
b) faulty tilt sensor
a) return the truck to a level
position before unloading
b) contact your local dealer or
Rice Lake Weighing Systems
for a tilt sensor Norac part #
42328.55
The alarm light stays
on all the time.
a) The scale up/down
sensor may be
damage or not
working.
a) Check that the finger shaped
reed switch is oriented properly
and not broken. (See sketch
following this table) – OR – make
sure the magnet has not fallen off
or been moved out of position.
Norac scale up/down sensor part
#42377
The cab alarm light
stays OFF all the
time.
a) Broken wire or
bad connection in
the cab alarm
assembly.
a) Fix broken wire or bad
connection – OR- replace cab
alarm assembly Norac part #
42331
The system will not
START or END or
both
a) Weight reading is
not stable enough
a) It may be too windy to get a
stable weight, check the
motion light on the indicator.
The system can only start and
end when the light is out.