Rice Lake TradeRoute HL Series - Low Profile Operators Manual for Models from 2011 and Older 127465 - Manual (Page 19)

16
4. Insert your ticket into the TM290 ticket printer.
5. The system is in IDLE condition and the display is showing a
stable GROSS weight, which is the starting weight.
If you have a delivery switch make sure the delivery hose,
chutes, conveyors, etc. must be in the storage position
before continuing.
If you don’t have a delivery switch make sure the delivery
hose, chutes, conveyors, etc. must be in position to
delivery product before continuing.
6. If your system has a delivery switch ensure it is “off”. Press
[START]. The prompt “setp” will appear, enter the target
weight. Set the target weight (set point) by entering the
following sequence into the M2000.
“#####” is the target weight.
If a mistake is made entering the target weight, pressing
[CLEAR] will abort the enter target weight phase. Press
[START] to start the enter target weight process again.
If the target weight has not been entered and the system
is not prompting you to enter a target weight, you will
need to press [START] again. You will then be prompted
to enter a target weight.
7. If the system is in Batch Weigh mode the system will prompt
“prod”, enter a product ID enter
“#####” is the product number.
If the product number has not been entered and the
system is not prompting you to enter a product number,
you will need to press [START] again. You will then be
prompted to enter a product number.