Rice Lake Intercomp CS 750 - Users Manual - Manual (Page 18)

CS750, Users
Rev R, May 2009
Page 18 of 27
Save
•
At this point the scale saves any changes that have been made. This allows
changes to be made to “EE-10 EE-10 EE-10 EE-10” through “EE-14 EE-14 EE-14 EE-14” without having to do a complete
calibration. The scale can be turned off and any changes so far will be saved.
Weight calibration
20. The scale shows “LL-00 LL-00 LL-00 LL-00”. With no weight on hook press the zero key. This
reads the pad zero. On the next screen, enter the scale's capacity.
21. The scale shows “LL-01 LL-01 LL-01 LL-01”. Apply the first weight. With the first weight stable
on the hook, press the zero key. Then enter the value of the applied weight.
22. The scale shows “LL-02 LL-02 LL-02 LL-02”. Apply the second weight. With the second weight
stable on the hook, press the zero key. Then enter the value of the applied
weight.
23. The scale shows “LL-03 LL-03 LL-03 LL-03”. Apply the third weight. With the third weight stable
on the hook, press the zero key. Then enter the value of the applied weight.
Finish
•
The new calibration information is saved.
24. Return the calibration blocking switch to it's original position (RUN). This
prevents accidental entry into the calibration mode.
25. Verify the calibration.
26. Calibration complete.
Legal-for-Trade Sealing
1. On the left side of the CS750, replace the 2 front screws with the drilled screws
provided.
2. Thread a lead & wire seal through the 2 screws on the left side.
3. Crimp the lead seal tightly.
4. On the right side of the CS750, replace the 2 front screws with the drilled screws
provided.
5. Thread a lead & wire seal through the 2 screws on the right side.
6. Crimp the lead seal tightly.