Rice Lake FX-i WP Series, A&D Weighing - Manual (Page 10)

8
2-2 Installing the Balance
Install the balance as follows:
1. Place the balance on a solid weighing table. Refer to “3. PRECAUTIONS” for installing the balance.
2. In case of FZ-i WP series and FX-120i WP / FX-200i WP / FX-300i WP
Assemble the pan support, weighing pan and breeze break, on the balance as shown in the
illustration on page 7.
In case of FX-1200i WP / FX-2000i WP / FX-3000i WP
Assemble the pan support and weighing pan on the balance as shown in the illustration on page 7.
3. Adjust the leveling feet to level the balance. Confirm it using the bubble spirit level.
4. Confirm that the AC adapter type is correct for the local voltage and power receptacle type.
5. Connect the AC adapter to the balance. Warm up the balance for at least 30 minutes with nothing
on the weighing pan.
Note
The AC adapter plug is protected against dust and may be difficult to insert. When inserting the
plug, turn the plug while pushing on it.