Rice Lake Counterpart Configurable Counting Indicator - User Manual Rev. D - Version 2.4 - Manual (Page 53)

Configuration 47
Gross, Net, Piecent, %REL
GROSS NET PIECECNT %REL
APPLIES TO GROSS, NET, PIECECNT, & %REL
SOURCE
LIST OF
SCALES
VALUE
number
TRIP
LOWER
HIGHER
OUTBAND
INBAND
BANDVAL
number
If TRIP=
INBAND or
OUTBAND
If TRIP=
HIGHER or
LOWER
HYSTER
number
PREACT
OFF
ON
LEARN
If PREACT=
ON or
LEARN
PREVAL
number
PRESTAB PCOUNT PREADJ
number
If KIND=
% RELSP
RELNUM
1-6
DIGOUT
NONE
1-4
SENSE
NORMAL
INVERT
ON
HIDE
OFF
ACCESS PSHPRNT
OFF
ON
WAITSS
PSHTARE
OFF
ON
PSHACCM
OFF
ON
NQUIET
BATCH
OFF
ON
If PREACT
=
LEARN
Sub-menu
Figure 3-20. Gross, Net, Piecent, %REL Sub-menu
Parameters Choices Description
SP CFG SETPT 1
SETPT 2-6 Specifies the settings for GROSS, NET, PIECECNT, % REL, delay, waitss, counter and
inmotion used by setpoints 1 through 6.
BATCHING OFF
AUTO
MANUAL Batching enable. Set to AUTO or MANUAL to allow a batch sequence to run. MANUAL
requires a Batch Start softkey before the batch sequence can run. AUTO allows batch
sequences to repeat continuously.
SP CFG subenu
SETPT1-6 OFF
GROSS
NET
PIECECNT
%REL
DELAY
WAITSS
COUNTER
INMOTION Specifies the setpoint kind.
GROSS, NET, PIECECNT, and %REL setpoint kinds can be used as either batch or continuous
setpoints. DELAY, WAITSS, and COUNTER setpoint kinds can only be used in batch
sequences.
The INMOTION setpoint kind can only be used as a continuous setpoint.
Table 3-17. Scale Setpoint Menu Parameters