Rice Lake Combination System - Precision Loads PL9700 Indicator - Manual (Page 21)

Special Operations 17
The following steps will select WEIGHT-TO-GO:
1. Press the Menu key to get the Function menu.
The information display will show Reset
Empty weight.
NOTE: If you do not continue with the operation within 15
seconds, the indicator will reset to the normal weighing mode
and you will need to press the Menu key again.
2. Press the Menu key again to show Select
Mode.
3. Press WTGO to select WEIGHT-TO-GO. The
red NET and GROSS LED lamps will be off.
You can press the Cancel softkey to exit the operation
at any time.
9.3 Setting the Transmitter Model
T h e P L 9 7 0 0 w i l l w o r k w i t h t h e S t r u c t u r a l
I n s t r u m e n t a t i o n S I - 9 1 0 0 a n d M - 1 0 0 1 2 - v o l t
transmitters. Because all transmitters have different
outputs, you will need to reset the TARE WEIGHT
every time you change to a different transmitter
model. You will also need to enter the CAL FACTOR
for the new transmitter.
For example, you have one truck that you use with
two different trailers. The truck uses the PNT9700
transmitter. One trailer has an SI-9100 transmitter and
the other trailer has a PNT9700 transmitter. First set
up the one that uses the SI-9100 transmitter. After
calibrating the trailer and you have verified with a few
loads that the system weighs correctly, record the
CAL FACTOR. Do the same for the second trailer that
uses the PNT9700 transmitter. Then, when you
change trailers, you only need to enter the correct
CAL FACTOR.
The following steps will guide you through changing
channel 1 from the PNT9700 transmitter to the
SI-9100 transmitter.
1. Press and hold the Menu key about 15 seconds
until the information display shows Advanced
Setup Menu.
After releasing the Menu key, the display will
show Setup selection.
2. Press the Up or Down key to select the
transmitter menu.
The display will show Transmitter Ch-1?
9700.
3. Press the 9100 softkey to select the SI-9100
transmitter.
The display will show Transmitter Ch-1 =
9100.
4. When finished, press the Cancel softkey to
exit the Advanced Setup Menu.
The information display will show Setup
selection.
To change channel 2 from the PNT9700 transmitter to
the SI-9100 transmitter, do the following:
1. Press and hold the Menu key about 15 seconds
until the information display shows Advanced
Setup Menu.
After releasing the Menu key, the display will
show Setup selection.
2. Press the Up or Down key to select the
transmitter menu.
The display will show Transmitter Ch-2?
9700.
3. Press the 9100 softkey to select the SI-9100
transmitter.
The display will show Transmitter Ch-2=
9100.
4. When finished, press the Cancel softkey to
exit the Advanced Setup menu.
The information display will show Setup
selection.