Rice Lake 920i Custom Grain Program - Manual (Page 14)

Supervisor Mode 11
4.5 Settings Shrink Calculation
1. Press the More => softkey to access the
Shrink Calculation softkey. The operator has
the choice of selecting either Off Gross
Weight or After Dockage softkeys.
Figure 4-15. Shrink Calculated
2. Select Off Gross Weight to calculate the
shrink off gross weight, or select After
Dockage to calculate the shrink after the
dockage has been removed.
The default value is off gross weight.
4.6 Printer Port
Select the Printer Port s oftkey to access port
information.
Figure 4-16. Printer Ports
The 920i displays the current printer port and lets the
operator press a softkey to change the printer port.
Notes: The default port is 2. If a keyboard is used, the
printer must be connected to a different serial port.
The 920i Grain Program was designed to support printers
with 38 columns or greater. Check with your local dealer
for compatible printers.
4.7 Removing Trucks
Trucks can be removed from the database by pressing
the
Remove Trucks softkey.
Figure 4-17. Remove Trucks
1. Scroll through the truck database by using the
Previous and Next softkeys.
2. To remove a truck from the database, press
the Delete softkey and the 920i prompts, Are
you sure you want to delete?
Figure 4-18. Delete Trucks
3. Press the Yes softkey to remove the truck
from the database or No to leave it.
4. To exit this mode, press the Exit => softkey.
4.8 Message Editing
When a weigh out ticket is printed without a contract,
a message is printed on the indicator. This message
can be edited from the supervisor mode.
1. Press the Message softkey, the indicator
prompts Enter Message on the upper status
line and an end greeting is displayed on the