Rice Lake 920i FlexWeigh Systems - 201/202 - Manual (Page 9)

Installation 5
2.0 Installation
This section describes procedures for setting up and getting the Flexweigh System 201/202 ready to weigh.
WARNING
The system has no on/off switch. Before opening the unit, ensure the power cord is disconnected from the
power outlet.
The power outlet supplying the indicator must be installed near the unit and be easily accessible.
CAUTION
Use a wrist strap to ground yourself and protect components from electrostatic discharge (ESD) when
working inside the indicator enclosure.
2.1 Unpacking and Assembly
Immediately after unpacking, visually inspect the unit to ensure all components are included and undamaged. The
shipping carton should contain the Flexweigh System unit and this manual. If any parts were damaged in shipment,
notify Rice Lake Weighing Systems and the shipper immediately.
2.2 Enclosure Disassembly
The Flexweigh System 201/202 must be opened to install option cards and to connect cables for installed option
cards.
WARNING Ensure power to the indicator is disconnected, then open the enclosure.
2.3 Cable Connections
See Figure 2-1 and Figure 2-2.
The Flexweigh System 201/202 provides eleven cord grips for cabling into the indicator. The parts kit includes cord
grip plugs to prevent moisture from entering the enclosure. Install these plugs into all cord grips that will not be
used in your application. Use the cable grounding instructions for wiring into the indicator.
Note
An additional adhesive label (121108) is included in the parts kit and can be installed at the
installer’s discretion indicating correct terminal block numbering.