Rice Lake 880 Performance Series Indicator/Controller Operators Manual - Manual (Page 13)

9 880 Operator’s Manual
Turn Setpoint On or Off
To turn a setpoint off at the front panel:
1. Press . AUDIT is displayed.
2. Press or until SETPTS is displayed.
3. Press and the first available setpoint number is displayed.
4. Press or to toggle through each setpoint that is operator accessible.
5. Press , then press or to
ENABLE/DISABLE
.
6. Press , then press or to turn setpoint
ON/OFF
.
7. Press to accept the setting.
8. Press to return to weighing mode.
Some indicator configurations may not allow setpoints to be turned off
through the front panel or may require a password to turn the setpoint on
and off.
1.4.11 Set Time and Date
1. Press ,
AUDIT
is displayed.
2. Press or until
T&D
is displayed.
3. Press ,
TIME
is displayed.
4. Press , to enter time.
5. To edit the value ( 24 hour format):
• Press or to select the digit.
• Press
or to increment or decrement the value.
6. Press when the value is correct.
DATE
is displayed.
7. Press , to enter time.
8. To edit the value in specified format (MMDDYY, DDMMYY, or YYMMDD):
• Press or to select the digit.
• Press
or to increment or decrement the value.
9. Press when the value is correct.
TIME
is displayed.
10. Press to return to weighing mode.
1.4.12 Display Accumulator
Enable accumulator before use in either normal mode or setpoint operations. Once
enabled, weight (net weight if a tare is in the system) is accumulated whenever a print
operation is performed using the
PRINT
key, digital input, setpoint
PSHACC
operation or
KPRINT
serial command. The scale must return to below the threshold
value (except for the setpoint
PSHACC
operation) before the next accumulation.
1. Press to enter the user setup mode, AUDIT is displayed.
2. Press or until ACCUM is displayed.
MENU
TARE
MENU
Note
MENU
TARE
TARE
MENU
MENU