Mercedes-Benz E-Class 2007 Owners Manual User Manual
Page 239
238
Controls in detail
Power windows
̈
Switch on the ignition (
Opening the windows
̈
Press switch
1 to 4 to the resistance
point.
The corresponding window will move
downwards until you release the
switch.
Closing the windows
̈
Pull switch
1 to 4 to the resistance
point.
The corresponding window will move
upwards until you release the switch.
Fully opening the windows
(Express-open)
̈
Press switch
1 to 4 past the resis-
tance point and release.
The corresponding window opens com-
pletely.
Fully closing the windows
(Express-close)
̈
Pull switch
1 to 4 past the resis-
tance point and release.
The corresponding window closes com-
pletely.
Stopping windows during Express-op-
eration
̈
Press or pull the respective power win-
dow switch again.
i
Operating the windows from the rear is not
possible if you activate the override switch
(
i
With the SmartKey in starter switch
position 0 or removed from the starter switch,
the windows can be operated:
ț
until you open the driver’s or front passen-
ger’s door
ț
for at least 5 minutes
Warning!
G
If you pull and hold the switch up when clos-
ing the window, and upward movement of
the window is blocked by some obstruction
including but not limited to arms, hands, fin-
gers, etc., the automatic reversal will not op-
erate.
Warning!
G
Driver’s door only:
If within 5 seconds switch is again pulled
past the resistance point and released, the
automatic reversal will not operate.
!
If the upward movement of the window is
blocked during the closing procedure, the win-
dow will stop and open slightly.
Remove the obstruction, pull the respective pow-
er window switch again past the resistance point
and release.
If the window still does not close when there is
no obstruction, pull and hold the respective pow-
er window switch. The window will then close
without the obstruction sensor function.