Mercedes-Benz S-Class 2008 COMAND Manual - Manual (Page 726)

725
Practical hints
Flat tire
The jack take-up brackets are located di-
rectly behind the front wheel housings and
in front of the rear wheel housings.
2 Jack take-up bracket
3 Jack
4 Crank
̈ Place jack 2 on firm ground.
̈ Position jack 3 under take-up
bracket 2 so that it is always vertical
(plumb-line) as seen from the side,
even if the vehicle is parked on an
incline.
̈ Turn crank 4 clockwise until jack 3
is fully seated in take-up bracket 2
and the jack base evenly meets the
ground.
̈ Jack up the vehicle until the wheel is a
maximum of 1.2 in (3 cm) from the
ground. Never start engine while
vehicle is raised.
Warning!
G
Position the jack only on the jack take-up
brackets designed for this purpose.
If the jack is not properly positioned, the ve-
hicle may fall off the jack and cause serious
personal injury or damage to the vehicle.
Warning!
G
The jack is intended only for lifting the
vehicle briefly for wheel changes. It is not
suited for performing maintenance work
under the vehicle.
ț Never start the engine when the vehicle
is raised.
ț Never lie down under the raised vehicle.