Mercedes-Benz S-Class 2008 COMAND Manual - Manual (Page 216)

215
Control systems
COMAND navigation system (entering a destination)
̈ Canceling an entry: Select “Back” in
the bottom line and press
n.
or
̈ Press back button L in the center
console ( ୴ page 88).
As soon as COMAND can clearly attribute
the characters entered to a center, the in-
put characters
7 disappear. You see the
list of centers without the input characters.
Here you can confirm the current entry or
make another selection.
During character entry, you can also man-
ually switch to the list of centers without
input characters at any time.
̈ Switching manually to the list of
centers without input characters:
Slide
q m.
or
̈ Select ? in the second line from the
bottom and press n.
List of centers without input characters
̈ Selecting a center: Slide q m r or
rotate y m z .
̈ Canceling selection: Select “Back”
and press
n.
or
̈ Press back button L in the center
console ( ୴ page 88).
̈ Confirming selection: Press n.
After the confirmation, the address in-
put menu appears again. It shows the
center, city and state (USA) or province
(CDN).
Which of the following menu items are now
available may depend on the data version
of the digital map. The menu items which
are not available cannot be selected.
ț “Map”: using the map to enter a desti-
nation (
୴ page 225)
ț “POI”: entering a point of interest
(
୴ page 229)
ț “Save”: saving a destination in the des-
tination memory (
୴ page 251)
ț “Start”: starting the route calculation
(
୴ page 222)
̈ Continuing or completing destina-
tion entry: Select one of the menu
items mentioned above.
i In this case, using the map for destination
entry is based on the center seen in the address
input menu.
i In this case, entering a point of interest is
based on the center seen in the address input
menu.