Mercedes-Benz S-Class 2008 COMAND Manual User Manual
Page 201
200
Control systems
COMAND navigation (introduction)
Geo-coordinate display
Illustration: map with geo-coordinate dis-
play switched on
1 Current height above sea level
2 Number of GPS satellites from which
signals for positioning can be received
3 Coordinate display
Display options with geo-coordinate dis-
play switched on
If the crosshair is displayed on the map
view (map was moved manually), only dis-
play
3 is visible.
It shows either the coordinates of the
crosshair or other data on the crosshair
position, e.g. a street name. The digital
map must contain relevant data in order
for this other data to be displayed.
Switching the geo-coordinate display on
or off
̈
Select “Navi”
Ǟ “Navi” Ǟ “Map Dis-
play”.
The map display list appears.
̈
Select “Coordinates”.
The geo-coordinate display is switched
on or off, depending on the previous
status. A checkmark indicates which
status is active.
̈
Exiting menu: Slide
o
m
p
or press
back button
L in the center console
(
୴
page 88).
i
There must be sufficient GPS reception for
displays
1, 2 and 3 to be shown. Height dis-
play
1 is an approximation because the naviga-
tion system uses the GPS signals for the
calculation.
i
If there is no crosshair on the map view, dis-
plays
1, 2 and 3 are visible. Display 3
shows the coordinates of the current vehicle po-
sition.