Mercedes-Benz CL-Class 2008 Owners Manual - Manual (Page 98)

97
Control systems
COMAND introduction
Adjusting surround sound
With surround sound, you can choose be-
tween “LOGIC7
® ON” and “LOGIC7 ® OFF”.
̈ Select “Sound”
Ǟ “3D Sound”.
Adjusting surround sound
1 Current setting
̈ Selecting a setting: Slide r m q or
rotate y m z .
̈ Saving setting: Press n.
The setting is saved and the menu is
closed.
̈ Exiting menu without saving chang-
es: Press
L or slide o m p .
Switching off/on the audio source
̈ Switching off: Select “Audio” Ǟ “Au-
dio” Ǟ “Audio OFF”.
The audio source is switched off; “Au-
dio OFF” appears in the display.
̈ Switching on: Select “Audio”, then the
desired audio source.
or
̈ Load CD/DVD ( ୴ page 116) or a
PCMCIA card ( ୴ page 117).
i By selecting “LOGIC7 ® OFF”, all compatible
formats as they are present on the medium are
played back. Due to the vehicle’s spatial charac-
teristics, an optimal sound experience is not en-
sured on all seats.
i Please note the following:
ț For an ideal sound experience at all seats,
the balance and fader should be adjusted to
the center of the passenger compartment
with LOGIC7
® switched on.
ț The best sound results are achieved by play-
ing high-quality audio CDs and audio DVDs.
ț For MP3 tracks, the bit rate should be at
least 128 kbit/s.
ț Surround sound does not function for
mono-signal sources.
ț In the event of poor radio reception quality,
e.g. inside a tunnel, you should switch off
LOGIC7
® , as a dynamic switch from Stereo
to Mono could occur, resulting in temporary
sound distortion.
ț With some stereo recordings, the resulting
sound may deviate from conventional stereo
playback.
i When you insert an audio CD or audio DVD,
it automatically becomes the active audio
source.