Mercedes-Benz CL-Class 2008 Owners Manual User Manual
Page 417
416
Controls in detail
Driving and parking
If you have started the engine with the
KEYLESS-GO start/stop button and can-
not turn it off as described above:
̈
Remove the KEYLESS-GO start/stop
button from the starter switch.
̈
Insert the SmartKey with KEYLESS-GO
into the starter switch.
The engine turns off. The starter switch
is in position 0 (
୴
page 365).
Releasing seat belts
̈
Press the seat belt release button
(
୴
page 389).
Allow the retractor to completely re-
wind the seat belt by guiding the latch
plate.
i
If you drive through an automatic conveyor
type car wash, you can switch on the ignition
with the KEYLESS-GO button and engage neutral
position N or insert the SmartKey into the starter
switch.
!
Make sure the seat belt retracts fully so that
the seat belt and/or latch plate cannot get
caught or pinched in the door or in the seat
mechanism. This can damage the seat belt and
impair the effectiveness of the seat belt, and/or
cause damage to the door and/or door trim pan-
el. Such damage is not covered by the
Mercedes-Benz Limited Warranty.
Damaged seat belts must be replaced. Contact
an authorized Mercedes-Benz Center.
୴୴