Mercedes-Benz CL-Class 2008 Owners Manual - Manual (Page 224)

223
Control systems
COMAND navigation system (entering a destination)
Entering predefined destinations
̈ Select “Navi” Ǟ “Destination” Ǟ
“Stopover”.
If a stopover has already been entered,
you can change it.
̈ Changing: Select “Change Stop-
over”.
You can now select a category.
̈ Selecting a category:
Select category, e.g. “Gas station”.
COMAND first looks for destinations
within the immediate vicinity of the ve-
hicle and near the vehicle’s route. If
there are no destinations available
there, COMAND searches for destina-
tions in an area around the vehicle po-
sition.
If COMAND does not find any destina-
tions, you will see a message to this ef-
fect.
̈ Select “OK”.
You can now select a different cat-
egory.
If COMAND finds destinations, you will
see a list of the destinations and details
of how far away they are in the
right-hand side of the display. The in-
formation about how far away the des-
tinations are can take a few seconds to
be displayed.
The left-hand part of the display shows
the destinations on the map. The desti-
nation marked in the list is highlighted
in the map.
̈ Selecting a destination: Select the
desired destination from list.
The address of the destination ap-
pears.
̈ Starting route calculation:
Select “Start”, see also (
୴ page 218).
Entering another destination as a
stopover
̈ Select “Navi” Ǟ “Destination” Ǟ
“Stopover”.
̈ Entering: Select “Other”.
You can select between the following
menu items:
ț “Address Entry”
ț “From Memory”
ț “From Last Destinations”
ț “From POIs”
̈ Select a menu item.