Mercedes-Benz CL-Class 2012 - Manual (Page 345)

When ATTENTION ASSIST ( Y page 316) is
activated, the À symbol appears in the
multifunction display when the ignition is on.
Activating/deactivating Active Blind
Spot Assist
You can use the Blind Spot Assist
function to activate or deactivate Active Blind
Spot Assist (
Y page 321).
X Press = or ; on the steering wheel
to select the
DriveAssist menu.
X Press 9 or : to select Blind Spot
Assist .
X Press a.
The current selection is displayed.
X To activate/deactivate: press a
again.
Activating/deactivating Active Lane
Keeping Assist
You can use the Lane Keeping Assist
function to activate or deactivate Active Lane
Keeping Assist (
Y page 324).
X Press the = or ; button on the
steering wheel to select the
DriveAssist
menu.
X Press the 9 or : button to select
Lane Keeping Assist .
X Press a.
The current selection is displayed.
X To activate/deactivate: press a
again.
If Active Lane Keeping Assist is activated, the
à symbol appears in the multifunction
display when the ignition is on.
Service menu
In the Service menu you can:
R
call up display messages ( Y page 346)
R
check the tire pressure electronically
(
Y page 449)
R call up the service due date ( Y page 413)
R
check the oil level ( Y page 409)
Settings menu
Introduction
The Settings menu can be used for:
R
switching the daytime running lamps on/
off
R switching Adaptive Highbeam Assist on/
off
R
showing or hiding the additional
speedometer
R selecting the units for speed and distance
R
activating/deactivating the radar sensor
system
Switching the daytime running lamps
on/off
This function is not available in Canada.
If you have activated the
Daytime Running
Light function and the light switch is in the
$ or c position, the daytime running
lamps are switched on automatically when
the engine is running.
In the dark, the following also light up:
R
the parking lamps
R
the tail lamps
R
the license plate lamp
R
the side marker lamps
If you turn the light switch to a different
position, the corresponding lights are
switched on. If you switch off the daytime
running lamps at night, make sure that the
light switch is set to L or c.
The factory setting is
On .
X Press the = or ; button on the
steering wheel to select the
Settings
menu.
X Press the 9 or : button to select
Day Running Lights .
Menus and submenus
343
On-board computer and displays
Z