Comand, Navigation – Mercedes-Benz CL-Class 2012 User Manual
Page 148
X
To select a category: select a category by
turning cVd the COMAND controller and
pressing W to confirm.
COMAND first searches in the selected
category for destinations along the route.
If there are no destinations available there,
COMAND searches for destinations within
a radius of up to 100 km of the vehicle
position.
If COMAND finds destinations, a list
appears on the right-hand side of the
display. The currently selected point of
interest is highlighted on the left-hand side
of the map.
The intermediate stops are listed according
to increasing distance from the current
vehicle position. They are displayed in the
form of a name and their position in relation
to the route and your direction of travel.
If COMAND does not find any destinations,
you will see a message to this effect.
X
Confirm
OK
by pressing W.
X
Select a different category.
X
Select the intermediate stop by turning
cVd the COMAND controller and pressing
W to confirm.
X
To start route calculation: select
Start
and press W to confirm.
Entering another destination as an
intermediate stop
X
To activate navigation mode: press the
S function button once or twice.
X
To show the menu: press W the COMAND
controller.
X
Select
Destination
in the navigation
system menu bar by turning cVd the
COMAND controller and pressing W to
confirm.
X
Select
Stopover
and press W to confirm.
X
Select
Other
and press W to confirm.
X
Select
Address Entry
,
From Memory
,
From Last Destinations
or
From POIs
.
Selection
Step
Address Entry
X
Enter a
destination by
address
(
From Memory
X
Select a
destination from
the destination
memory
(
From Last
Destinations
X
Select a
destination from
the list of last
destinations
(
From POIs
X
Enter a point of
interest
(
X
To start route calculation: once you have
entered a destination, select
Start
and
press W to confirm.
Deleting an intermediate stop
If an intermediate stop has already been
entered, you can delete it.
X
To activate navigation mode: press the
S function button once or twice.
X
To show the menu: press W the COMAND
controller.
X
Select
Destination
in the navigation
system menu bar by turning cVd the
COMAND controller and pressing W to
confirm.
X
Select
Stopover
and press W to confirm.
146
Navigation
COMAND