Mercedes-Benz CL-Class 2012 - Manual (Page 273)

R no engine-relevant diagnostics are active.
R
the driver's door is closed and the seat belt
is fastened.
Automatic engine start
The engine is started automatically if you:
R
release the brake pedal when HOLD is not
activated and the transmission is in
position
D or N
R
shift the transmission to position R
R depress the accelerator pedal
R switch off the ECO start/stop function or
switch to drive program
S or M
R
unfasten your seat belt or open the driver's
door
The engine is also started automatically if:
R the vehicle starts to roll.
R
the brake system requires this.
R
the system detects moisture on the
windshield when the air-conditioning
system is switched on.
R
the temperature in the vehicle interior
deviates from the set range.
R
the charge level of the battery is too low.
Deactivating/activating the ECO start/
stop function
General information
You can deactivate and activate the ECO
start/stop function using COMAND
(
Y page 231).
i You can also use the programmable
button ( Y page 109) to activate and
deactivate the ECO start/stop function if
you have assigned this function to the
button.
Deactivating
X Deactivate the ECO start/stop function
using COMAND (
Y page 231):
The ¤ ECO symbol goes out and the
Stop/Start deactivated display
message is shown in the multifunction
display.
i If drive program S or M has been selected,
the ECO start/stop function is always
deactivated.
Activating
X Activate the ECO start/stop function using
COMAND (
Y page 231).
The ¤ ECO symbol and the Stop/
Start active display message are shown
in the multifunction display.
If not all conditions for automatic engine
switch-off are fulfilled (
Y page 270), the
Stop/Start inactive message appears.
i If you activate the ECO start/stop
function in drive program S or M, drive
program C is selected automatically.
Driving
271
Driving and parking
Z