Kontron KTT20-pITX - Manual (Page 21)

KTD-S0044-G Page 17 Graphics Processing Unit
KTT20/pITX User's Guide
7.5.2 LVDS Connector Backlight Pins
The following table is an extract of the J1700 connector overview.
Pin Signal Description Type
1 - 5 VDD 1) Normal backlight voltage PWR
6 and 8 GND Ground PWR
Note: 1) To protect the external power lines of peripheral devices make sure that
- the wires have the right diameter to withstand the maximum available current.
- to enclosure of the peripheral device fulfills the fire-protecting conditions of IEC/EN 60950.
7.5.3 External Backlight Voltage Parameter
Parameter Min. Typ. Max. Units
Backlight voltage +5.0 +12.0 +15.0 V
Continuous current fixed power +5V tbd. A
Continuous current per pin
on connector J401
0.5 A