Kontron KTT20-pITX - Manual (Page 18)

KTD-S0044-G Page 14 Graphics Processing Unit
KTT20/pITX User's Guide
7.2 LVDS Flat Panel Connector
The J1700 connector (40 pins) provides the LVDS interface for flat panels on the top side of the board. A
prototype cable with open ends is available (part number 821515).
Header Pin Signal Description Type
1 - 5 VDD 1) Backlight voltage PWR
6 GND Ground PWR
7 VCC5 1) Power +5V PWR
8 GND Ground PWR
9 PANELVCC 1) Panel power +3.3V or +5V PWR
10 PANELVCC 1) Panel power +3.3V or +5V PWR
11 - 12 N.C. Not connected NC
13 BKLTADJ Brightness control (0V to +5V) AO
14 VCCENA Panel power enable (PANELVCC signal) O-33/O-50
15 BKLTON Backlight on/off O-50
16 GND Ground PWR
17 FTX0- First channel data 0 output (negative) DSO-33
18 FTX0+ First channel data 0 output (positive) DSO-33
19 FTX1- First channel data 1 output (negative) DSO-33
20 FTX1+ First channel data 1 output (positive) DSO-33
21 FTX2- First channel data 2 output (negative) DSO-33
22 FTX2+ First channel data 2 output (positive) DSO-33
23 FTXC- First channel clock output (negative) DSO-33
24 FTXC+ First channel clock output (positive) DSO-33
25 FTX3- First channel data 3 output (negative) DSO-33
26 FTX3+ First channel data 3 output (positive) DSO-33
27 - 28 GND Ground PWR
29 - 32 N.C. Not connected NC
33 PANELVCC 1) Panel power +3.3V or +5V PWR
34 VCC5 1) Power +5V PWR
35 SPICLK SPI TM clock signal O-18
36 SPISDO SPI TM serial data output O-18
37 SPISDI SPI TM serial data input I-18
38 SPICS# SPI TM chip select O-18
39 - 40 GND Ground PWR