Kontron AT8060 - Manual (Page 80)

Software Setup
65 AT8060
www.kontron.com
5. Software Setup
5.1 AMI UEFI Setup Program
All relevant information for operating the board and connected peripherals is stored in the main BIOS
section of the SPI.
5.1.1 Accessing the UEFI Setup Utility
The Unified Extensible Firmware Interface (hereafter known as UEFI) provides an interface between the
operating system and the hardware of the AT8060. It uses the AMI Setup program, a setup utility in flash
memory that is accessed by pressing the key at the appropriate time during board boot. This utility is
used to set configuration data in the SPI.
To run the AMI Setup program incorporated in the SPI:
• Turn on or reboot the board.
• When you get the following messages, hit key to enter SETUP.
The main menu of the AMI Aptio Setup Utility appears on the screen.
Setup Default values provide optimum performance settings for all devices and system features.