Kontron AT8060 - Manual (Page 106)

Software Setup
91 AT8060
www.kontron.com
5.1.5 Chipset
Stop Bits 1, 2
Stop bits indicate the
end of a serial data
packet. (A start bit
indicates the
beginning). The
standard setting is 1
stop bit. Communication
with slow devices may
require more than 1 stop
bit.
Flow Control
None, Hardware
RTS/CTS
Flow control can prevent
data loss from buffer
overflow. When sending
data, if the receiving
buffers are full, a 'stop'
signal can be sent to
stop the data flow. Once
the buffers are empty, a
'start' signal can be sent
to re-start the flow.
Hardware flow control
uses two wires to send
start/stop signals.
VT-UTF8 Combo Key
Support
Disabled, Enabled
Enable VT-UTF8
Combination Key
Support for ANSI/VT100
terminals
Recorder Mode Disabled, Enabled
With this mode enabled
only text will be sent.
This is to capture
Terminal data.
Resolution 100x31 Disabled, Enabled
Enables or disables
extended terminal
resolution
Legacy OS Redirection
Resolution
80x24, 80x25
On Legacy OS, the
Number of Rows and
Columns supported
redirection
Force System Vga to Text
Mode
Disabled, Enabled
Enable to Install Linux in
text mode When System
has Vga.
Feature Option Description Help text
North Bridge Selects sub-menu. North Bridge Parameters
South Bridge Selects sub-menu.
South Bridge
Parameters
ME Subsystem Selects sub-menu.
ME Subsystem
Parameters
Feature Option Description Help text