Kontron AT8060 - Manual (Page 102)

Software Setup
87 AT8060
www.kontron.com
Flow Control
None, Hardware
RTS/CTS, Software
Xon/Xoff
Flow control can prevent
data loss from buffer
overflow. When sending
data, if the receiving
buffers are full, a 'stop'
signal can be sent to
stop the data flow. Once
the buffers are empty, a
'start' signal can be sent
to re-start the flow.
Hardware flow control
uses two wires to send
start/stop signals.
Data Bits Display only Data Bits
Parity Display only
A parity bit can be sent
with the data bits to
detect some
transmission errors.
Even: parity bit is 0 if the
num of 1's in the data
bits is even. Odd: parity
bit is 0 if num of 1's in
the data bits is odd.
Mark: parity bit is always
1. Space: Parity bit is
always 0. Mark and
Space Parity do not
allow for error
detection. They can be
used as an additional
data bit.
Stop Bits Display only
Stop bits indicate the
end of a serial data
packet. (A start bit
indicates the
beginning). The
standard setting is 1
stop bit. Communication
with slow devices may
require more than 1 stop
bit.
Feature Option Description Help text