3 console redirection (vt100 mode), 1 requirements, 2 ansi and vt100 keystroke mapping – Kontron AT8060 User Manual
Page 123: 3 vt-utf8 keystroke mapping, Requirements, Ansi and vt100 keystroke mapping, Vt-utf8 keystroke mapping

Software Setup
108
www.kontron.com
5.3
Console Redirection (VT100 Mode)
The VT100 operating mode allows remote setup of the board. This configuration requires a remote terminal
that must be connected to the board through a serial communication link.
5.3.1
Requirements
The terminal should emulate a VT100 or an ANSI terminal. Terminal emulation programs such as Putty,
Telix©, HyperTherminal(Windows), minicom(Linux) or ProComm©(Windows) can also be used.
5.3.2
ANSI and VT100 Keystroke Mapping
5.3.3
VT-UTF8 Keystroke Mapping
The following "escape sequences" are defined in the "Conventions for Keys Not in VT100 Terminal Definition
and ASCII Character Set" section of "Standardizing Out-of-Band Management Console Output and Terminal
Emulation (VT-UTF8 and VT100+)",available for download at microsoft.com.
Up
Down
Right
Left
Home
End
F1
F2
F3
F4
F1 Key
F2 Key
F3 Key
F4 Key
F5 Key
F6 Key
F7 Key
F8 Key
F9 Key
F10 Key