Kontron CP371 - Manual (Page 4)

Preface CP371
Page iv © 2002 PEP Modular Computers GmbH ID 23762, Rev. 02
Chapter
2
2. Functional Description ................................................................................ 2 - 3
2.1 General Information ............................................................................... 2 - 3
2.1.1 Signal Conditioning ....................................................................... 2 - 3
2.1.2 Analog to Digital Converter ........................................................... 2 - 3
2.1.3 ADC ProComm Controller ............................................................. 2 - 4
2.1.4 System Interfaces ......................................................................... 2 - 4
2.1.5 Monitor and Control ....................................................................... 2 - 4
2.1.6 Software ........................................................................................ 2 - 4
2.2 Board-Level Interfacing Diagram ........................................................... 2 - 4
2.3 System Interfaces .................................................................................. 2 - 6
2.3.1 Analog Input Interface ................................................................... 2 - 6
2.3.2 CPCI Interface and Pinout ............................................................ 2 - 8
2.3.3 Test and Program Development .................................................... 2 - 9
2.4 CapROM EEPROM ............................................................................... 2 - 9
2.5 Monitor and Control (M/C) ..................................................................... 2 - 9
2.5.1 Pre-Operation M/C ........................................................................ 2 - 9
2.5.2 Operation M/C ............................................................................ 2 - 10
Chapter
3
3. Installation ................................................................................................... 3 - 3
3.1 Hardware Installation ............................................................................. 3 - 3
3.1.1 Safety Requirements ..................................................................... 3 - 3
3.1.2 Installation Procedures .................................................................. 3 - 4
3.1.3 Removal Procedures ..................................................................... 3 - 5
3.2 Software Installation .............................................................................. 3 - 5