Kontron CP371 - Manual (Page 25)

CP371 Introduction
ID 23762, Rev. 02 © 2002 PEP Modular Computers GmbH Page 1 - 9
1.6 Technical Specifications
Table 1-3: CP371 Main Specifications
GROUP TYPE DESCRIPTION
ADC ProComm
Controller and
Related
FPGA Logic Device Provides PCI interfacing and IO control logic
Peripheral
Memory
CapROM 4 kBit (512 byte) EEPROM
External
Interfaces
Analog Input One, 62-pin, female, three row, D-sub connector
Supports up to sixteen analog input channels
CPCI Bus One, 132-pin, female, six row connector (standard CPCI type
connector for J1)
Internal Interfaces
JTAG/ISP JTAG/ISP 10-pin SMD connector for programming and testing
purposes
Indicators
Front Panel LED Two, green LED’s for indicating cluster operation status
(enabled or disabled)
General
Mechanical Conforms with IEEE 1101.1
Power Requirements Voltages: 3.3 V
5 V VCC
Power Consumption Voltages: 3.3 V = 0.132 W
5 V = 1.9 0 W
Temperature Range Operational: 0ºC to +70ºC Standard
-40ºC to +85ºC E2
Storage: -55ºC to +125ºC
Humidity 0% to 95% non-condensing
Dimensions 100 mm x 160 mm single height Eurocard
Board Weight 152 g (2 cluster configuration)
Software Driver
Information
(See note below)
PCI Header Device ID: 0x5555
Vendor ID: 0x1556
Class Code: 0x118000
Subsystem Device ID: 0x00D0
Subsystem Vendor ID: 0x1518
Note...
The Device ID and Vendor ID refer to the chip manufacturer. In the Class Code
value given, “11” relates to the data acquisition and signal processing control-
lers and “8000” relates to the Analog IO modules. Subsystem Device ID and
Subsystem Vendor ID are defined by PEP.
In addition, the CP371 uses 64kB in PCI memory space, BAR0, is not prefetch-
able, and no interrupts are used.