Kontron CP382 - Manual (Page 49)

CP382 Configuration
ID 24208, Rev. 01 © 2002 PEP Modular Computers GmbH Page 4 - 7
4.3.2 Writing Output Data
Table 4-2: Output Data Register Bit Map
Bits Type Default Function
31-8 r/w 0 Reserved
7-0 r/w 0 Data, 8 bit digit
Note...
Output data is 8 bit (each cluster); this register is read/write enable.
Table 4-3: Output Control Register
Bits Type Default Function
31-2 r/w 0 Reserved
1 r/w 0 irqen
0 r/w 1 Reset
Note...
irqen is for diagnostic issuing an interrupt.
The reset bit should be set to 0 to activate a cluster.
Table 4-4: Output Status Register, Bit Map
Bits Type Default Function
31 r 0 Fail
30 r 0 Diag
29-0 r 0 Reserved
Note...
The Diag status flag is the diagnostic bit from the HSD switch; Fail is the latched
diag status flag.