Kontron CP382 - Manual (Page 35)

CP382 Functional Description
ID 24208, Rev. 01 © 2002 PEP Modular Computers GmbH Page 2 - 9
2.4 CapROM EEPROM
The CapROM is a 4 kBit (512 byte) EEPROM which provides the capability to store board con-
trol relevant information to allow software configuration of the CP382.
2.5 Monitor and Control (M/C)
The front panel of the board is equipped with two LED’s for user defined purposes. One green
(RUN) and one red (FAIL) have been placed on the front panel in anticipation of their most likely
use. However they are freely programmable, the indicators being selected by the system mas-
ter (access to the hardware debug register (hdr)).
The system failure indicators regarding undervoltage, overcurrent and overtemperature are
made available to the DO ProComm controller. These indicators are automatically reset by the
HSD switches once the conditon has been corrected and the output returns to normal mode.
An input signal Halt/Reset is available to set an inactive state for each individual cluster and
also to shut down each individual cluster during operation as necessary.