Kontron CP382 - Manual (Page 23)

CP382 Introduction
ID 24208, Rev. 01 © 2002 PEP Modular Computers GmbH Page 1 - 7
1.5 Technical Specifications
Table 1-3: CP382 Main Specifications
GROUP/
INTERFACE
TYPE DESCRIPTION
DO ProComm
Controller and
Related
FPGA Logic Device Provides CompactPCI interfacing and IO control logic
Peripheral
Memory
CapROM 4 kBit (512 byte) EEPROM
CompactPCI
Interface
(See note at foot
of table)
Realized on 132-pin,
female, six row connec-
tor (standard CPCI type
connector for J1) Bus Width: 32-bit, Bus Speed: 33 MHz
64 kB memory space, non-prefetchable
PCI Header:
Device ID:
0x5555
Vendor ID: 0x1556
Class Code: 0x110000
Subsystem Device ID: 0x00F0
Subsystem Vendor ID:
0x1518
Digital Output
Interface
One 62-pin, female,
three row, D-sub con-
nector Supports up to 24 digital output channels
Indicators Front Panel LED’s One green and one red LED to indicate operational status
General
Form Factor 3U, 4HP
Mechanical Conforms with IEEE 1101.1
System Power Con-
sumption + 3.3V: maximum 860 mW (all 24 channels activated)
Temperature Range Operational: 0ºC to +70ºC Standard
-40ºC to +85ºC E2
Storage: -55ºC to +125ºC
Humidity 0% to 95% non-condensing
Dimensions 100 mm x 160 mm single height Eurocard
Board Weight 155 grams
Note...
The Device ID and Vendor ID refer to the chip manufacturer. In the Class Code
value given, “11” relates to the data acquisition and signal processing control-
lers and “0000” relates to the DPIO modules. Subsystem Device ID and Sub-
system Vendor ID are defined by PEP.