Gastroback 40964 Design Food Processor Pro - Manual (Page 7)

45 45
rements for safe operation of the appliance. Thus, before operating the appliance abroad,
ensure that safe operation is possible.
• Do not to use any extension cords or desk top multi socket outlets.
• Always handle power cords with care. Always completely unwind the power cord before
use. Do not place the appliance on a power cord. Power cords may never be knotted, twis-
ted, pulled, strained or squeezed. Do not let the plug or power cord hang over the edge of
the table or counter. The power cord may not touch hot surfaces or sharp edges. Ensure that
no one will pull the appliance by the power cord. Take care not to entangle in the power
cord. Always grasp the plug to disconnect the power cord. Do not touch the power plug with
wet hands when the appliance is connected to the power supply.
• When liquids are spilled on the motor base or power cord, immediately unplug the
appliance. Thereafter, clean the appliance and let it dry for at least 1 day. See: Care and
Cleaning
Moving parts — Risks of injuries
The appliance is intended for cutting, chopping and mixing food. Thus,
moving/cutting parts of the appliance can cause severe injuries, when used
contrary to these instructions.
• Do not insert your hands, hair, clothes, brushes, or other foreign objects (e.g. bones, stalks
of vegetables, cooking utensils) in the feed chute of the appliance, when the appliance is
connected to the power supply. Only use the provided pusher to push down the ingredients.
Do not push with violence, to avoid that the motor gets blocked.
• The blades of the tools are very sharp. Handle with care! Only touch the cutting
tools at the black plastic parts to avoid injuries. Do not attempt to use more than one set of
cutting tools simultaneously, unless it is described in the instructions in this booklet this way.
• Do not hold your face over the feed chute, while the motor is agitating, because food and
liquids could splash through the feed chute. Moreover, splinters could escape from the feed
chute, if you failed to see small pieces of bones or other hard parts (e.g. shells, stones) while
preparing the foods. DO NOT push the foods with your hands down in the feed chute, or
poke in the feed chute!
• Always assemble the appliance according to the instructions in this booklet completely and
correctly, before connecting the appliance to the power supply. Doing so, be aware, that
the motor will start IMMEDIATELY, if the ON/OFF button is set to ON at this moment. Thus,
always ensure that the appliance is always ready for working, before connecting to the po-
wer supply. Always switch OFF (indicator in the ON/OFF button goes out) the appliance via
the ON/OFF button first, when setting it out of operation. This holds also, when the motor
suddenly stops agitating due to overheating or braking of a safety interlock.