Gastroback 42526 Design Multicook Plus User Manual

Page 27

Press the ›Menu‹-button or the › + ‹ and › – ‹-buttons to select

the program ›Jelly‹. Once ›Jelly‹ flashes on the LED-display the

program is selected. The LED-display shows the default values for

the temperature and cooking time.
4.

Use the ›Timer / t °C‹-button to reach the time selection

mode. The minute indicator flashes. Use the › + ‹ and › – ‹-buttons to adjust the time. With the

›Hour / Min‹-button you can switch between hours and minutes. The LED-display shows the

pre-set cooking time 6 hours. You can adjust the cooking time from 1 hour to 8 hours.
5.

If necessary, adjust the Auto-Start-Function to start cooking later.

Press and hold for a few seconds, the ›Start / Keep Warm on / off‹-button to start the appli-

ance. The ›Start / Keep Warm on / off‹-button lights up and the countdown of the cooking time

is shown in the time indicator.
7.

The Keep-Warm-Function turns on automatically immediately after the program is over. If

necessary, this function can be switched off by pressing and holding the ›Start / Keep Warm

on / off‹-button at any time.
8.

After completion of the program an acoustic signal will sound. Depending on the settings of

the appliance, the Keep-Warm-Function will launch (the LED display counts up the time) or the

appliance will return to standby mode.
9.

To cancel the selected program, to interrupt the cooking process or the Keep-Warm-Function

press and hold the ›Cancel / Keep Warm‹-button for a few seconds.

program steam

Recommended for steaming vegetables, fish, meat, dumplings, etc. The setting range of the

time is 5 minutes to 2 hours in 5-minute steps. The countdown of the program will start after

reaching the operating temperature (boiling water and steam development).
1.

Pour about 600-1000 ml of water into the inner pot. Place the steam insert inside the inner pot.

Prepare the ingredients according to the recipe. Place these evenly in the steam insert and

install the inner pot into the housing. Make sure that the inner pot is firmly in contact with the

heating element.
3.

Close the lid until it clicks into place. Connect the appliance to the power outlet.

Press the ›Menu‹-button or the › + ‹ and › – ‹-buttons to select

the program ›Steam‹. Once ›Steam‹ flashes on the LED-display

the program is selected. The LED-display shows the default

values for the temperature and cooking time.
5.

Use the ›Timer / t °C‹-button to reach the time selection

mode. The minute indicator flashes. Use the › + ‹ and › – ‹-buttons to adjust the time. With the

›Hour / Min‹-button you can switch between hours and minutes. The LED-display shows the

pre-set cooking time 6 hours. You can adjust the cooking time from 5 minutes to 2 hours.
6.

If necessary, adjust the Auto-Start-Function to start cooking later.

Press and hold for a few seconds the ›Start / Keep Warm on / off‹-button to start the appli-

ance. The ›Start / Keep Warm on / off‹-button lights up. The countdown of the cooking time will

start after reaching the operating temperature (boiling water and steam development).