Gastroback 42526 Design Multicook Plus User Manual

Page 25

If necessary, adjust the Auto-Start-Function to start cooking later.

Press and hold for a few seconds the ›Start / Keep Warm on / off‹-button to start the appli-

ance. The ›Start / Keep Warm on / off‹-button lights up and the countdown of the cooking time

is shown in the time indicator.
7.

The Keep-Warm-Function turns on automatically, immediately after the program is over. If

necessary, this function can be switched off by pressing and holding the ›Start / Keep Warm

on / off‹-button at any time.
8.

After completion of the program an acoustic signal will sound. Depending on the settings of

the appliance, the Keep-Warm-Function will launch (the LED-display counts up the time) or the

appliance will return to standby mode.
9.

To cancel the selected program, to interrupt the cooking process or the Keep-Warm-Function

press and hold the ›Cancel / Keep Warm‹-button for a few seconds.
You can use a wooden skewer or toothpick to check the doneness of your cake. If there is no

dough sticking to the toothpick after inserting into the cake, your cake is ready.
During preparation of bread, disable the ›Keep Warm‹-Function at all stages of the cooking

process.

program pilaf

The program is recommended for the preparation of various types of pilaf (long cooked stew with

rice, meat and carrots). The setting range of the time is 10 minutes to 2 hours in 5-minute steps. The

24-hour Auto-Start-Function is available for this program.
1.

Prepare the ingredients according to the recipe. Place these evenly in the inner pot and

insert the inner pot into the housing. Please make sure that all ingredients, including liquids,

are below the maximum mark (10 Cup) on the inner surface of the inner pot. Make sure that

the inner pot is firmly in contact with the heating element.
2.

Close the lid until it clicks into place. Connect the appliance

to the power outlet.
3.

Press the ›Menu‹-button or the › + ‹ and › – ‹-buttons to select

the program ›Pilaf‹. Once ›Pilaf‹ flashes on the LED-display the

program is selected. The LED-display shows the default values

for the temperature and cooking time.
4.

Use the ›Timer / t °C‹-button to reach the time selection mode. The minute indicator flashes.

Use the › + ‹ and › – ‹-buttons to adjust the time. With the ›Hour / Min‹-button you can switch

between hours and minutes. The LED-display shows the preset cooking time 1 hour. You can

adjust the cooking time from 10 minutes to 2 hours.
5.