Gastroback 42526 Design Multicook Plus - Manual (Page 23)

4. Press the ›Menu‹-button or the › + ‹ and › – ‹-buttons to select
the program ›Bread‹. Once ›Bread‹ flashes on the LED-display
the program is selected. The LED-display shows the default
values for the temperature and cooking time.
5.
Use the ›Timer / t °C‹-button to reach the time selection
mode. The minute indicator flashes. Use the › + ‹ and › – ‹-buttons to adjust the time. With the
›Hour / Min‹-button you can switch between hours and minutes. The LED-display shows the
pre-set cooking time 2 hours. You can adjust the cooking time from 10 minutes to 6 hours.
6.
Keep in mind that during the first hour of the program, the ferment takes place. Thereafter
the baking begins.
7.
Press and hold for a few seconds the ›Start / Keep Warm on / off‹-button to start the appli-
ance. The ›Start / Keep Warm on / off‹-button lights up and the countdown of the cooking time
is shown in the time indicator.
8.
The Keep-Warm-Function turns on automatically, immediately after the program is over. If
necessary, this function can be switched off by pressing and holding the ›Start / Keep Warm
on / off‹-button at any time.
9.
After completion of the program an acoustic signal will sound. Depending on the settings of
the appliance, the Keep-Warm-Function will launch (the LED-display counts up the time) or the
appliance will return to standby mode.
10.
To cancel the selected program, to interrupt the cooking process or the Keep-Warm-Func-
tion press and hold the ›Cancel / Keep Warm‹-button for a few seconds.
Before baking, we recommend sift the flour, to remove any foreign matter and to enrich the
flour with oxygen.
We do not recommend to use Auto-Start-Function, as this may lead to impairment of baking
quality.
Do not open the appliance until the baking process is complete, as this can also lead to im-
pairment of baking quality.
To save time and simplify the preparation, we recommend the use of ready mixes for bread.
program Deep Fry
This program is suitable for deep-frying. The setting range of the temperature is 120 °C -
180 °C in steps of 5 °C. The setting range of the time is 5 minutes to 30 minutes 5-minute steps.
The countdown of the program will start after reaching operating temperature.
The 24-hour Auto-Start-Function is not available for this program.
1.
Prepare the ingredients according to the recipe. Assemble the frying basket by inserting the
handle into the holder provided from above. Add the oil into the inner pot and insert the inner
pot into the housing. Please make sure that all ingredients, including liquids, are below the
maximum mark (10 Cup) on the inner surface of the inner pot. Make sure that the inner pot is
firmly in contact with the heating element.
2.
Close the lid until it clicks into place. Connect the appliance
to the power outlet.
3.
Press the ›Menu‹-button or the › + ‹ and › – ‹-buttons to select
the program ›Deep Fry‹. Once ›Deep Fry‹ flashes on the LED-
64 65