Gastroback 42526 Design Multicook Plus - Manual (Page 12)

54
If necessary, this function can be switched off by pressing and holding the ›Start / Keep Warm
on / off‹-button. The corresponding indicator will switch off. This function can also be turned
on or off during operation at any time.
warm-up Function
With the Design Multicook Plus you can also reheat cold food.
1.
Place the food in the inner pot and insert it into the appliance.
2. Close the lid, and connect the appliance to the power outlet.
3. Press and hold the ›Cancel / Keep Warm‹-button for a few seconds. Keep Warm indicator
on the display and the LED button will be light on. The time indicator will start shows the
elapsed heating time.
The appliance heats the dish to 70 - 80 °C and will keep it in tis state for 24 hours. This func-
tion can also be turned on or off during operation at any time by pressing and holding the
›Start / Keep Warm on / off‹-button. The corresponding indicator will switch off.
Although the appliance can keep the food in a heated state up to 24 hours, it is not recom-
mended to warm up your dish for more than two or three hours, as this can lead to a change
in taste and consistency.
program Multicook
This program is suitable for almost any kind of food, because you can adjust the temperature
and cooking time required. The setting range of the temperature is 35 °C - 180 °C in steps of
5 °C. The setting range of the time is 2 minutes to 15 hours in 1-minute steps (for the range up
to 1 hour) or 5 minutes steps (for a time interval of more than 1 hour).
note: The appliance does not switch to keep warm mode when the cooking temperature is
selected below 75 °C. When the cooking temperature is more than 140 °C, the cooking time
may not exceed 2 hours.
The 24-hour Auto-Start-Function is available for this program.
1.
Prepare the ingredients according to the recipe. Place these evenly in the inner pot and
insert the inner pot into the housing. Please make sure that all ingredients, including liquids,
are below the maximum mark (10 Cup) on the inner surface of the inner pot. Make sure that
the inner pot is firmly in contact with the heating element.
2.
Close the lid until it clicks into place. Connect the appliance to the power outlet.
3. Press the ›Menu‹-button or the › + ‹ and › – ‹-buttons to select
the program ›Multicook‹. Once ›Multicook‹ flashes on the
LED-display the program is selected. The LED-display shows
the default values for the temperature and cooking time. (The
pre-set cooking time is 30 minutes, the pre-set cooking tempe-
rature is 100 °C.)
4.
Use the ›Timer / t °C‹-button to reach the time selection mode. The minute indicator flashes.
Use the › + ‹ and › – ‹-buttons to adjust the time. With the ›Hour / Min‹-button you can switch
between hours and minutes. The LED-display shows the pre-set cooking time 30 min. You can
adjust the cooking time from 2 minutes to 15 hours.