Gastroback 42526 Design Multicook Plus User Manual

Page 11

Alteration of the cooking time

During operation of the Design Multicook Plus you can adjust the cooking time regardless of

the pre-set time of the program. The steps and the total time depend on the selected program.
to change the cooking time:
1.

After selecting a cooking program, you can use the ›Timer / t °C‹-button to reach the time

selection mode. The time indicator flashes.
2.

Press the ›Hour / Min‹-button to select hours or minutes. The selected position flashes.

Press the ›+‹-button to increase the time, or press the › – ‹ button to decrease the time. By

holding the button, you can accelerate the changing of the time.
4.

After finishing the time setting (display continues to flash), you can make further adjustments,

for example, by pressing the ›Preset‹-button for a few seconds.
To cancel your settings, press the ›Cancel / Keep Warm‹-button and select the desired cooking

mode again.

the Auto-start-Function

With this function, you can set a time interval after which the selected program will start. The

start of the program can be delayed from 5 minutes to 24 hours, each in 5 minutes steps.
1.

Select a cooking program with the desired settings.

Press the ›Preset‹-button to enter the time setting mode of the Auto-Start-Function. The minu-

tes of the time indicator flash.
3.

By pressing the ›Hour / Min‹-button choose to set hours or minutes. The selected position

flashes.
4.

Press the ›+‹-button to increase the time, or press the › – ‹ button to decrease the time. By

holding the button, you can accelerate the changinging of the time.
5.

After setting the time, press and hold the ›Start / Keep Warm on / off‹-button for a few se-

conds. The time display will stop flashing and the appliance starts to operate and shows the

countdown until the start of the selected program.
6.

To cancel your settings, press the ›Cancel / Keep Warm‹-button. Then select the desired

cooking mode again.
The Auto-Start-Function is available for all programs except ›Fast Cook‹ and ›Deep Fry‹.
It is not recommended to set the Auto-Start-Function for a longer period of time, if your recipe

contains perishable foods (eggs, fresh milk, meat, cheese, and so on).
When setting the time for the Auto-Start-Function you should take into account that countdown of the

program ›Steam‹ begins only after reaching the required operating temperature (boiling water).
During the countdown of the Auto-Start-Function, you cannot turn on or off the acoustic signal.

keep-warm-Function

The Keep-Warm-Function turns on automatically immediately after the pro-

gram is over, and keeps the temperature of the prepared meal in the range

70 - 80 °C for 24 hours. The corresponding indicator on the LED display lights

up, and the time display shows the elapsed time.