Run a warm up period – ETS-Lindgren HI-6113 Laser Data Interface and Probe Measurement System User Manual
Page 18
18
|
Quick Start to Operation
7.
The USB driver for the HI-6113 automatically downloads and installs
when the HI-6113 is plugged into a computer that is connected to the
Internet and that is installed with one of the following supported
Microsoft Windows operating systems:
Windows XP operating system
Windows Vista® Client operating system
Windows Vista Client x64 operating system
Windows 7 Client operating system
Windows 7 Client x64 operating system
If you use an operating system not listed, please contact
ETS-Lindgren.
If your computer is not connected to the Internet, or it is connected but
the automatic installation failed or was cancelled, you will need to
download the drivers from
and manually install
them on your computer.
Go t
On the Resources menu, click Software/Firmware.
In the Software column, click USB Virtual Comm Port Driver
(the name of the zip file may vary slightly). Save the zip file to the
desired location on your computer.
Extract the files from the downloaded zip file.
In the same section on the ETS-Lindgren website where the driver is
located, click the link to download the installation instructions. Follow
those instructions to install the USB driver on your computer.
Run a Warm Up Period
Prior to starting a test, allow time for the Field Probe to warm up. Depending on
the ambient temperature, 5 to 10 minutes of run time are required for a sufficient
warm up period.