ETS-Lindgren HI-6113 Laser Data Interface and Probe Measurement System - Manual (Page 17)

Quick Start to Operation | 17
3.0 Quick Start to Operation
Before connecting any components, follow the
safety information in the ETS-Lindgren
Product Information Bulletin included with your
shipment.
Download and Install the Software
Download ProbeView  Laser software from www.ets-lindgren.com , and then
install it on the host computer. For download and installation steps, see
ProbeView Laser Software on page 23.
Connect the Hardware
1. Remove the protective caps from the fiber optic cables for the
HI-61XX Series Field Probe and clean the connectors with the
provided cleaning kit.
When disconnecting and connecting the fiber cables, always clean the
ends prior to re-connecting.
2. Remove the protective caps from the HI-6113 Laser Data Interface and
use compressed air to dislodge any obstruction within the connectors.
3. Connect the fiber optic cables by matching ST to ST and FC to FC.
Both connectors are keyed.
4. Connect the standard end of the USB cable to an available USB port
on the host computer.
5. Connect the mini-USB end of cable to the HI-6113.
6. Connect the DC power supply to the HI-6113. The power LED on the
HI-6113 should indicate green, and Microsoft® Windows® will
recognize and acknowledge the HI-6113.