Installation procedure, Caution – Elecraft K3 Crystal Filter Manual User Manual

Page 6

Text mode
Original mode

Installation Procedure

Disconnect power and all cables from your K3.

Remove the nine screws to free the top cover as shown in Figure 2. After the front edge of the cover is

opened as shown in the figure, set the unit back on its bottom feet and lift the cover gently to reach the speaker
wire connector. Unplug the speaker then set the top cover aside in a safe place.

REMOVE SCREWS HOLDING TOP COVER.

PLACE UNIT ON ITS SIDE FEET, THEN

TIP FARTHER SO THE TOP COVER

SWINGS OPEN FAR ENOUGH TO GRASP.

Figure 2. Removing K3 Top Cover.

CAUTION:

Touch an unpainted metal ground or wear a grounded wrist strap

before touching components or circuit boards inside the K3. See Preventing ESD Damage on

page 4 for more information.