beautypg.com

I (identify, get only) – Elecraft KXPA100 Programmers Reference User Manual

Page 15

background image

15

^FT (ATU Full Search Tune, SET only, with ^FE response)

SET format: ^FT;

^FT; starts a Full Search Tune. If Mode is Bypass, the Mode is changed to Manual.

An ^FE; RESPONSE is sent when a Full Search Tune initiated by ^FT; completes. Use ^FE to cancel a full
search tune in progress.

This command is ignored if the optional KXAT100 Antenna tuner is not installed.

^I (Identify, GET only)

GET format: ^I;

RESPONSE format: ^IKXPA100;

Note: KXPA100 permanent boot block firmware responds to I with “kxpa100;” in lower case.

See also other documents in the category Elecraft Accessories communication: