Step 11) appling the glass stop cover – EFCO 526 Series User Manual

Page 49

Text mode
Original mode

EFCO 6/2012

Page 49

Series 526 Impact Installation Instructions

The glass stop cover (16G4) is snapped in place after the drive-in gasket is glazed. It may
be necessary to use a soft face mallet to snap the cover into place. Start by pressing the
cover down so that it will clear the frame snap leg, then run it to the other end.

SECTION VIII: Glazing

Step 11) Appling the Glass Stop Cover

Hit with a soft

face mallet at

this corner.

Press the cover

snap leg past the

frame snap leg.

[Fig. 54]