Dynojet Compressed Air Air/Fuel Ratio Module User Manual
Page 29
O N - B O A R D D Y N O I N S T A L L A T I O N
Installation
Version 5
Compressed Air Air Fuel Ratio Module Installation and User Guide
A-3
3
Run the provided air hose from the air pump assembly to the front of your dyno.
If you have an air brake, refer to “Installing the Air Hose with the Air Brake” on
page A-4.
You will need to remove the carriage assembly and top center cover to route the
air hose. Refer to your dyno installation guide for instruction on removing the top
cover.
4
Route the air hose through the air access holes in the front of the dyno.
5
Attach the hose to your air supply.
6
Attach the sensor.
7
Attach the silicone hose and copper sample tube to the sensor block.
8
Attach the sensor cable to the corresponding cable from the inside back panel of
the dyno.
9
Attach the connector from the pump solenoid to the cable on the inside back
panel of the dyno.
10 Replace the top center cover and carriage assembly.
11 Replace the drum module panel using the screws removed earlier.
Figure A-2: Installing the Sensor and Copper Sample Tube
silicon tube
copper sample
tube
sensor
attach air
solenoid connector