Installation, Compressed air requirements, Installing the pump assembly on the dyno – Dynojet Compressed Air Air/Fuel Ratio Module User Manual
Page 28
Compressed Air Air Fuel Ratio Module Installation and User Guide
A P P E N D I X A
Installation
A-2
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
INSTALLATION
This section describes how to install the compressed air pump assembly on your
motorcycle dynamometer.
C
OMPRESSED
A
IR
R
EQUIREMENTS
The following requirements are needed for the on-board compressed air pump
assembly:
• Clean and dry air, 100 psi or greater, 5 CFM or better flow
• Fittings to hook your air system to a 3/8-inch inside diameter hose (if no air brake is
present)
• optional air regulator
I
NSTALLING
THE
P
UMP
A
SSEMBLY
ON
THE
D
YNO
1
Remove the eight screws securing the drum module panel to the dyno. Set the
screws and the panel aside. For more information on removing the panel, refer to
your dyno installation guide.
2
Secure the pump housing to the dyno using four 1/4-20 torx screws.
Figure A-1: Install the Pump Housing
pump housing