Dynojet Air Fuel Ratio Module User Manual
Page 14
Air Fuel Ratio Module Installation and User Guide
C H A P T E R 2
Sample and View Air Fuel Ratios
2-4
4
Verify the Air Pump Assembly is on.
5
Press the green sample button on the pendent to begin recording data.
Note: For more information on how to make a run, refer to the WinPEP 7 User
Guide (on your WinPEP CD or at www.dynojet.com/manuals.shtml) or the
WinPEP 7 Online Help.
6
Press the sample button a second time to stop sampling.
Figure 2-4: MakeRun Screen—Sampling
7
Once you have completed your runs, allow the air pump to run for five minutes.
Always allow the air pump to run after the dyno runs are complete to clear all
water from the filter bowl and allow the air pump to cool.
Be sure to turn the Air Fuel Heater off when not in use for long periods of time.
air/fuel gauge